|
|
On this page:
Specifications
The 8x8 Broadband Phone Service Adapter connects a regular analog phone to your high-speed Internet service to enable 8x8 VoIP phone service.
By connecting standard telephones (cordless ones and headsets included) with broadband connections (Cable or DSL), 8x8 subscribers have the ability to make phone calls over the Internet at a fraction of the cost of traditional phone services. The Broadband Phone Adapter can be installed at the subscriber's premise in minutes. Equipped with two switched Ethernet ports and two RJ-11 phone service ports, the BPA410 adapter connects with your home router or gateway and your standard, existing telephones. Because the BPA410 adapters allow you to have two separate 8x8 service plans - in essence, two phone lines from one box and one broadband connection: you can have two separate phone calls happening at the same time. The second Ethernet port can be used for connecting your PC or other networked device without adding an extra Ethernet switch hub. (See diagram below.) The adapter is necessary to use 8x8 Residential and Virtual Office services.
8x8 subscribers can make and receive calls from any telephone in the world. Using your regular telephone with a BPA410 and 8x8 Internet phone service to make Internet phone calls is easier and more natural than using a computer with a microphone and speakers.
Specifications
- Dimension (H x W x D) : 1.22 x 6.69 x 4.72 inches
- Weight: 9 oz. (approx.)
- Power consumption: 3.5W to 4.5W (idle to peak)
- DC input voltage: +12V, 1.0A
- Power adapter:
Universal, 100-200Vac 47-63Hz input
~4.0 x 2.0 x1.4 in,
~6.5 oz, ~5ft DC cord,
~6ft AC cord
- Ring voltage: 45Vms typical (balanced ringing)
- Ring waveform: Sinusoidal
- Max ringer load: 3REN
- On hook voltage: ~48V (nominal)
- Off hook current: 20mA
- 2 RJ11 FXS port impedance: 600 ohm resistive
Hardware Features:
- Audacity-T2U processor IC
- 384 Kbyte on-chip SRAM, 16-way interleave
- 16 Kbyte, 2-way set associative cache for external FLASH
- 32 channel DMA engine
- 6.4 GB memory controller
- 2 MB FLASH
- 2 Ethernet 10/100 Base-T MACS
- Multimedia codec compatibility via TDM port
- 6 indicator lights for Power, Link, Line 1/2, and Message 1/2
- User configurable
Software Features:
- SIP call signaling protocol stack
- IETF RFC2543
- IETF RFC2833
- T.38 Fax Relay
- ANSI C implementation
- Downloader application
- Remote configuration through HTTP
- Web-based user interface
Audio Subsystem:
- G.711, G.723.1, G.726, G.729A/B
- G.165/G.168, Line echo cancellation
- Tone generation: dial, busy, ring-back
- Dynamic jitter buffer
- DTMF detection/generation
- Inband and out-of-band DTMF support
- Voice activity detection
- Comfort noise generation
- FAX/modem tone detection
- Caller ID generation (FSK)
Network Layer:
HTTP, RTP, RTCP, TFTP, TCP, UDP, DHCP, DNS, ARP, ICMP, NTP, IGMPv2, 802.1
P/Q (VLAN)
|
|